104
Solution Ultima 844/862/880 Installation Manual
To change data in the current location, enter the new value (0 – 15) followed by the button.
This will store the new data into the location and still leave you positioned at the same location. You
will notice that the new information programmed will be displayed on the codepad indicators (e.g.. If
you enter the value
14 followed by the button, both ZONE 4 and the MAINS indicator will
illuminate).
To move to the next location, press the
button. The data in the next locations data will now be
displayed.
To exit the Installer’s Programming Mode, enter command
960 followed by the button.
Two beeps will be heard and the
STAY and AWAY indicators will extinguish. The system will now
return to the disarmed state and is now ready for use.
Refer to Installer’s Programming Commands on page 107 for further information on commands that
can be performed during access of Installer’s Programming Mode.
ISSUE162.DOC Electronics Design and Manufacturing Pty Limited
To Next Page
Loading...