EDM Solution Ultima 844 - Page 14

Consumer Options 2 __________________________________________________________________________ 232
Codepad Display Extinguish After 60 Seconds ___________________________________________________ 232
Single Button Arming Allowed (AWAY Mode, STAY Mode 1 & 2) __________________________________ 232
Single Button Disarming Allowed (STAY Mode 1 & 2) ____________________________________________ 232
Alarm Memory Reset On Disarm______________________________________________________________ 232
Consumer Options 3 __________________________________________________________________________ 233
Codepad Fault Alarm Beeps Allowed __________________________________________________________ 233
Use Digit 3 For Codepad Duress Instead Of Digit 9 _______________________________________________ 233
Alarms Activate Siren & Strobe In STAY Mode 1 & 2 _____________________________________________ 233
Zone Tamper Alarms To Be Silent_____________________________________________________________ 233
Radio Input Options __________________________________________________________________________ 234
DS304 MHz Receiver (RF3212) ______________________________________________________________ 234
Latching Keyswitch Input____________________________________________________________________ 234
Momentary Keyswitch Input _________________________________________________________________ 234
Partitioning_____________________________________________________________________ 235
CP5 Master Partitioned LED Codepad ___________________________________________________ 236
Zone Indicators ______________________________________________________________________________ 236
Area On/Off Indicators ________________________________________________________________________ 237
Area Display Indicators _______________________________________________________________________ 237
Status Indicators _____________________________________________________________________________ 237
PARTIAL Indicator ________________________________________________________________________ 237
AUX Indicator ____________________________________________________________________________ 238
MAINS Indicator __________________________________________________________________________ 238
FAULT Indicator __________________________________________________________________________ 238
Audible Indicators _________________________________________________________________________ 239
Operating Codepads In Partitioning _____________________________________________________ 240
Operating From A CP5 Area Addressable LED Codepad ___________________________________________ 240
Operating From A CP5 Master Partitioned Codepad _______________________________________________ 240
Programming ________________________________________________________________________
Partitioning Options 1_________________________________________________________________________ 241
First To Open/Last To Close Reporting _________________________________________________________ 241
Area 1Codepad Connected To Data Terminal ____________________________________________________ 241
Reset Sirens From Any Area Allowed __________________________________________________________ 242
Master Codepad To Display AUX Indicator When On-Line _________________________________________ 242
Partitioning Options 2_________________________________________________________________________ 242
Lock Area 1 To Receiver 1 and Lock Area 2 To Receiver 2 _________________________________________ 242
User Code Allowed To Arm/Disarm Both Areas At Same Time ______________________________________ 242
Reserved _________________________________________________________________________________ 242
Reserved _________________________________________________________________________________ 242
Zone Allocations ______________________________________________________________________
Zone Allocations For Area 1 ___________________________________________________________________ 243
Zone Allocations For Area 2 ___________________________________________________________________ 243
User Code Allocations _________________________________________________________________
Setting Up and Programming Codepads For Partitioning____________________________________
Setting Up The Master Partitioned Codepad As The Main Codepad. __________________________________ 246
Setting Up An Area 1 Codepad As The Main Codepad _____________________________________________ 246
Setting Up An Area 1 Codepad _______________________________________________________________ 246
Setting Up An Area 2 Codepad _______________________________________________________________ 246
Codepad Connections For Partitioning - Examples _________________________________________ 247
RF Information _________________________________________________________________ 249
RF Option Bit _______________________________________________________________________________ 250
Sound Siren On RF Receiver Fail______________________________________________________________ 250
Sound Siren On RF Receiver Tamper / Jamming__________________________________________________ 250
Unseal Zone That Fails Supervision____________________________________________________________ 250
Enable RF Jamming Monitoring_______________________________________________________________ 250
RF Device Mapping (Devices 1 – 8) _____________________________________________________________ 250
RF Device Mapping (Devices 9 – 16) ____________________________________________________________ 250
RF Device Signal Strength (Devices 1 – 8 Read Only) _______________________________________________ 251
RF Device Signal Strength (Devices 9 – 16 Read Only) ______________________________________________ 251
241
243
245
246