Introduction 23
How To Set The Date and Time
1. Enter your followed by 6and the button.
Three beeps will be heard and the
STAY and AWAY indicators will begin to flash.
2. Enter the day, month, year, hour and minute using the (DD, MM, YY, HH, MM) format (i.e.
DD = Day of the month, MM = Month of the year, YY = Current year, HH = Hour of the day,
MM = Minute of the day).
Please note that when programming the hour of the day, you will need to use 24:00 hour
format.
3. Press the
button when finished.
Two beeps will be heard and the
STAY and AWAY indicators will extinguish. If a long beep is
heard, an error was made when entering the date and time.
+
6
+
+
DD
+
MM
+
YY
+
HH
+
MM
+
Example
If the date and time needs to be set for the 1st January 1997 at 10:30 PM, program the date and time as
follows;
2580
+
6
+
+
01
+
01
+
97
+
22
+
30
+
Electronics Design and Manufacturing Pty Limited ISSUE162.DOC
To Next Page
Loading...