EDM Solution Ultima 844 - Page 9

Strobe Test ________________________________________________________________________________ 94
Turning Day Alarm On and Off ________________________________________________________________ 95
Fault Analysis Mode _________________________________________________________________________ 95
Initiate A Modem Call _______________________________________________________________________ 96
Reset Latching Outputs _______________________________________________________________________ 96
Codepad Buzzer Tone Change _________________________________________________________________ 97
Send Test Report____________________________________________________________________________ 97
Remote System___________________________________________________________________ 99
Operations Via Telephone__________________________________________________________ 99
Remote Arming Via The Telephone _____________________________________________________ 100
Programming___________________________________________________________________ 101
Programming________________________________________________________________________
Programming With The Remote Codepad ________________________________________________
Programming With The Hand Held Programmer__________________________________________ 105
Programming With The Programming Key_______________________________________________ 106
Programming Option Bits _____________________________________________________________
Installer’s Programming Commands ____________________________________________________
Command 958 - Enable/Disable Zone Status Mode __________________________________________________ 108
Command 959 - Test Programming Key __________________________________________________________
Command 960 - Exit Installer's Programming Mode _________________________________________________ 110
Command 961- Reset Control Panel Back To Factory Default Settings___________________________________ 110
Command 962 - Copy Control Panel Memory To Programming Key ____________________________________ 111
Command 963 - Copy From Programming Key To Control Panel_______________________________________ 112
Command 964 - Erase Programming Key _________________________________________________________
Command 965 - Set Up Domestic Dialling Format __________________________________________________
Command 966 - Enable/Disable Automatic Stepping Of Locations______________________________________
Command 999 - Display Panel Type Or Software Version Number _____________________________________
Disable Factory Default _______________________________________________________________________
Defaulting The Control Panel ___________________________________________________________________ 119
Alarm Link Operations ___________________________________________________________ 121
Alarm Link Software _________________________________________________________________
Remote Connect _____________________________________________________________________________
Remote Connect With Customer Control ________________________________________________________ 122
Remote Connect Without Call Back Verification __________________________________________________
Remote Connect With Call Back Verification ____________________________________________________
Direct Connect ____________________________________________________________________________
Alarm Link Options __________________________________________________________________________
Enable Upload/Download Via Alarm Link_______________________________________________________
Enable Alarm Link Call Back _________________________________________________________________
Terminate Alarm Link Connection On Alarm ____________________________________________________ 124
Use External Modem Module (CC811) For Alarm Link Operations ___________________________________
Domestic Dialling _______________________________________________________________
Domestic Dialling Format______________________________________________________________ 126
Domestic Dialling Function ____________________________________________________________________ 126
Acknowledge Domestic Dialling ______________________________________________________________ 126
Setting Up and Programming Domestic Reporting___________________________________________________ 127
Disable Domestic Dialling ___________________________________________________________________ 128
Dialler Reporting Formats ________________________________________________________ 129
Transmission Formats ________________________________________________________________ 130
Contact ID Format ___________________________________________________________________________ 130
Point ID Codes ______________________________________________________________________________ 131
4+2 Reporting Format_________________________________________________________________________ 133
Basic Pager Reporting Format __________________________________________________________________ 134
102
103
107
107
109
113
114
115
117
118
122
122
123
123
123
124
124
124
124
125