Fujitsu 1FINITY L100 - Page 14

Compliance Information—
General Industry
FCC
This equipment has been tested and found to comply with the limits for Class A digital devices, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protecon against harmful interferences when the equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate radio energy and if not installed in accordance with the
instrucon manual, may cause harmful interference to radio communicaons. Operaon of this equipment in a residenal area is likely to
cause harmful interference, which the user will be required to correct at his/her expense.
Industry Canada
This digital apparatus does not exceed the Class A limits for noise
emissions from digital apparatus set out in the Radio Interference
Regulaons of the Canadian Department of Communicaons to
ICES-003.
Cet appareil numérique ne dépasse pas les limites d'émission de
bruit pour les appareils numériques de Classe A tel que dénit dans
le document NMB-003 publié par le Département Canadien de
Communicaons.
CE Markings—
CE Cercaon
All 1FINITY systems meet all requirements for CE marking. It is compliant with the following standards:
■ 93/68/EEC (CE Marking)
■ 2014/30/EU (EMC Direcve)
■ 2015/863 (RoHS Direcve)
■ 2014/35/EU (Low Voltage Direcve)
■ 2012/19/EU (WEEE Direcve)
■ IEC 60950-1, IEC 60825-1, EN 60950-1, EN 60825-1 and all related requirement
■ Laser IEC/EN 60825-2 Standards
■ 21 CFR Chapter 1, Sub chapter J, Class 1 Laser Product
■ Class A Emission limits for the following standards:
• FCC Part 15, Class A (U.S.A.)
• ICES-003, Class A (Canada)
• CISPR Publicaon 32 Class A (Europe)
■ Product safety regulatory standards:
• UL 60950-1, 2nd Edion, 2014-10-14 (Informaon Technology Equipment-Safety—Part 1: General Requirements)
• CAN/CSA C22.2 No. 60950-1-07, 2nd Edion, 2014-10 (Informaon Technology Equipment-Safety—Part 1: General Requirements)
• IEC 60950-1:2005 (Second Edion): Am1:2009 + Am2:2013
• IEC/EN 60825-1 (Safety of laser products—Part 1: Equipment classicaon and requirements)
• IEC/EN 60825-2 (Safety of laser products—Part 2: Opcal bre communicaon systems [OFCS])