Fujitsu 1FINITY L100 - Equipment Removal

9
Equipment Removal
In this chapter:
9.1 Remove Filler Panel
9.2 Remove SFP Module
9.3 Remove Plug-In Unit
9.4 Remove Fan Unit
9.5 Remove Power Cables
9.6 Remove Blade from Rack
9.7 Remove Blade from Housing
The procedures described in this secon are used to remove L100 Blades, PIUs, pluggable modules, and other
required equipment in 19- or 23-inch, 2- or 4-post racks or the 1FINITY Housing.
The following tools and equipment are required:
■ Common hand tools
■ DMM
Equipment Removal
423
Release 19.1.1 · Issue 1.1, May 2021
Fujitsu and Fujitsu Customer Use Only