Fujitsu 1FINITY L100 - System Time and Date

6.4
System Time and Date
In this secon:
6.4.1 Show System Time and Date
6.4.2 Set System Time and Date Manually
6.4.3 Congure NTP
6.4.4 Congure System Time Zone
User can set system me and date in two ways: manually or through the network using NTP. Regardless of how
the user chooses to set system me and date, the user sll needs to set the system me zone.
6.4.1
Show System Time and Date
Command:
> show system-state clock datetime
Output Example:
system-state clock datetime 2018-04-26T10:23:44
[ok]
6.4.2
Set System Time and Date Manually
Command:
> request set-current-datetime current-datetime <YYYY-MM-DDTHH:MM:SS>
Command Example:
> request set-current-datetime current-datetime 2018-04-26T10:23:44
Note: If the NTP is enabled, this operaon fails with message status set-current-datetime is
unavailable when NTP is enabled.
6.4.3
Congure NTP
Show System NTP Conguraon
Command:
% show system ntp
System Administration
System Time and Date
212
Release 19.1.1 · Issue 1.1, May 2021
Fujitsu and Fujitsu Customer Use Only