Fujitsu 1FINITY L100 - Provision L100 Tributary Blade OTSOMSOCH Interfaces

Note: If autoprovisioning is enabled, the E-SC-E1 port interface is automacally provisioned.
Command:
% set interfaces interface eth-2/0/0/E-SC-E1 type ethernetCsmacd ethernet admin-
status up mtu 1800 speed 1000
Step 9
Provision the UTLP equipment.
Command:
% set eqpt shelf 2 slot 0 subslot 0 port UTLP pluggableInterfaceType Fixed
Note: If a user provisions any UTLP equipment in an earlier release, use the following commands.
Commands:
% delete eqpt shelf 2 slot 0 subslot 0 port UTLP
% set eqpt shelf 2 slot 0 subslot 0 port UTLP pluggableInterfaceType Fixed
Note: If a user provisions any UTLP equipment and UTLP interface in an earlier release, use the following
commands.
Commands:
% delete interfaces interface eth-2/0/0/UTLP
% delete eqpt shelf 2 slot 0 subslot 0 port UTLP
% set eqpt shelf 2 slot 0 subslot 0 port UTLP pluggableInterfaceType Fixed
Step 10
Provision the UTLP port interface.
Command:
% set interfaces interface eth-2/0/0/UTLP type ethernetCsmacd ethernet duplex full
speed 1000 mtu 1522 auto-negotiation enabled admin-status up
Connue with the next task.
7.11.2
Provision L100 Tributary Blade OTS/OMS/OCH Interfaces
Step 1
Enable opcal transport.
Command:
% set interfaces interface ots-2/0/0/E1 type opticalTransport enabled
ROADM Turn-Up and Operations
Adding Degree to ROADM Node
268
Release 19.1.1 · Issue 1.1, May 2021
Fujitsu and Fujitsu Customer Use Only