Fujitsu 1FINITY L100 - Install Power Terminal Adapter

4.9
Install Power Terminal Adapter
Prerequisites:
■ Screwdriver set (including straight-slot and Phillips head)
■ The blade to be installed in a rack
Aenon: The power terminal adapter is not used with the 1FINITY Housing opon.
Note: Fujitsu recommends installing the power terminal adapter on the blade before installing the blade into
the rack (2-post or 4-post).
Step 1
Remove the protecon cover from the power terminal adapter.
Protection
Cover
FNC000504_Rev_01
Figure 59
Removing Protecon Cover
Step 2
Inspect the power terminal adapter for possible physical damage and note the connecng hooks on the rear of
the adapter.
Note: If the power terminal adapter is observed to be damaged, set the adapter aside for repair and return
paperwork processing. Obtain another power terminal adapter for installaon.
Equipment Installation
Install Power Terminal Adapter
131
Release 19.1.1 · Issue 1.1, May 2021
Fujitsu and Fujitsu Customer Use Only