Fujitsu 1FINITY L100 User Manual

Command Descripon
le Perform le operaons
p Open a p session to another host
help Provide help informaon
id Show user id informaon
monitor Show real-me debugging informaon
quit Exit the management session
request Make system-level requests
set Set CLI properes
set-path Set relave show path
sp Open a sp session to another host
show Show informaon about the system
ssh Start a secure shell to another host
ssh-key-remove Remove host from know hosts le
start Start specied program or command
telnet Establish a Telnet session to another host
top Exit to top level and oponally run command
up Exit one level of conguraon
6.2.2
CLI Conguration Mode
To change CLI Session from operaonal mode to conguraon mode, enter the congure command.
Command:
> configure
When the CLI session is in the conguraon mode, the command prompt terminates with the "%" character.
Command Example:
fujitsu@fujitsu%
In conguraon mode, all changes to the device conguraon are inially done to a copy of the acve
conguraon called the candidate conguraon. These changes do not take eect unl a successful commit or
commit conrm command is entered. Commit acvates the candidate conguraon on the device. Candidate
conguraons enable the user to alter the conguraon without causing potenal damage to the current
network operaons.
System Administration
About CLI
205
Release 19.1.1 · Issue 1.1, May 2021
Fujitsu and Fujitsu Customer Use Only

Fujitsu 1FINITY L100 Specifications

General

Brand	Fujitsu
Model	1FINITY L100
Category	Server
Language	English