EasyManua.ls Logo

Fujitsu 1FINITY L100 - EnableDisable Secondary Database

Fujitsu 1FINITY L100
473 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Note: Depends on the user safety/environment requirements.
USB ash drive requirements:
L
H
W
FNC000626_Rev_01
Figure 166
USB Flash Drive 2.0 Dimensions
Interface: USB 2.0 compable
Capacity: 4…32 GB
Note: Minimum 4 GB is required and larger than 32 GB can be used by design, but maximum 32 GB is
proved in tesng.
Minimum R/W speed: Read 20 Mb/s, write 10 Mb/s
Maximum dimensions (W x L x H): 21.5 x 45 x 10 mm
Enable/Disable Secondary Database
The USB ash drive is enabled or disabled using the following CLI commands. The default value of usb-
secondary is enable.
Enable the USB ash drive secondary database.
Command:
% set system database usb-secondary enable
Disable the USB ash drive secondary database.
Command:
% set system database usb-secondary disable
Save the changes.
Command:
% commit
System Maintenance
Backup and Restore
418
Release 19.1.1 · Issue 1.1, May 2021
Fujitsu and Fujitsu Customer Use Only

Table of Contents

Related product manuals