Fujitsu 1FINITY L100 - Install Power Cables

4.12
Install Power Cables
The following links lead to related informaon:
Power Specicaons
Install Power Terminal Adapter
Remove Power Cables
Tools required:
■ Power terminal adapter aached to the blade
■ Screwdriver set (including straight-slot and Phillips head)
■ DMM
■ Terminang cable lugs bent at 90 degrees
Danger: Make sure both A and B power feeds are turned o, at the source, before starng this procedure.
Use properly insulated tools and perform all safety precauons in accordance with local safety pracces
when working on or around power terminals, power cables, and power connectors. Contacng power
terminals, uninsulated conductors, cable wiring, or any connector that could be part of a live electrical
circuit can result in death or serious personal injury.
Aenon: This procedure is not applicable if using the 1FINITY Housing opon.
Step 1
If not already done, remove the protecon cover from the power terminal adapter.
Equipment Installation
Install Power Cables
141
Release 19.1.1 · Issue 1.1, May 2021
Fujitsu and Fujitsu Customer Use Only