7.15
Reprovision L100 Blade for FLASHWAVE 9500 Interoperability
Note: Reprovisioning of the L100 Blade is necessary if the E-SC-E1 SFP slot is already in use.
Step 1
Remove the SFP in the E-SC-E1 SFP slot.
Step 2
Delete the E-SC-E1 port equipment.
Command:
% delete eqpt shelf 1 slot 0 subslot 0 port E-SC-E1
Step 3
Delete the E-SC-E1 port interface.
Commands:
% delete interfaces interface ots-1/0/0/E1
% delete interfaces interface eth-1/0/0/E-SC-E1
Step 4
Proceed to Provision L100 Blade for FLASHWAVE 9500 Interoperability.
✓ This task is complete.
ROADM Turn-Up and Operations
Reprovision L100 Blade for FLASHWAVE 9500 Interoperability
281
Release 19.1.1 · Issue 1.1, May 2021
Fujitsu and Fujitsu Customer Use Only
To Next Page
Loading...
