Fujitsu 1FINITY L100 - Limitations on Load Configuration

A.3
Limitations on Load Conguration
In this secon:
A.3.1 Fabric and Port-Connecon
A.3.2 SNMPv3
A.3.3 Fujitsu Opcal Interfaces
A.3.4 RollBack
A.3.5 Load Conguraon with Large Database
A.3.6 LLDP
A.3.1
Fabric and Port-Connection
Dierent Conguraon File from Running Database
If the running conguraon consists of fabric and port connecons and the conguraon is dierent from the
conguraon le, the user needs to delete all fabric- and port-connecon enes from the database rst and
execute the load replace operaon.
Fabric X
Config File:
Running Config:
Shelf 1 Shelf 2
Port-Connection A
Fabric Y
Shelf 3 Shelf 4
Port-Connection B
Fabric X
Shelf 1 Shelf 2
Port-Connection A
FNC001285_Rev_01
Figure 187
Restoring Conguraon
In the preceding gure, the user restores the conguraon le onto the system. The user needs to delete fabric
X, fabric Y, port-connecon A, and port-connecon B before execung the load replace operaon.
Load
Conguration Operation
Limitations on Load Conguration
454
Release 19.1.1 · Issue 1.1, May 2021
Fujitsu and Fujitsu Customer Use Only