Fujitsu 1FINITY L100 User Manual

Step 2
Provision the OTS interface.
Command:
% set interfaces interface ots-2/0/0/E1 type opticalTransport ots circuit-id OTS-2
fiber-type smf degree-number 2 operation-mode owb-fj-base admin-status up
Step 3
Provision the OMS interface.
Command:
% set interfaces interface ots-2/0/0/E1 type opticalTransport ots oms circuit-id
OMS-2
Step 4
Provision the OCH interface.
Command:
% set interfaces interface ots-2/0/0/E1 type opticalTransport ots oms och 1 center-
frequency 196.10 slot-width 50
Step 5
Repeat the preceding step for each OCH interface (1…96) to be provisioned.
Step 6
Verify the interfaces are provisioned correctly.
Command:
% show interfaces
Connue with the next task.
7.11.3
Provision Add/Drop Port Connections
Step 1
Provision an ADD connecon between a PIL1-3PS2 edge port and the L100 client port.
Command:
% set port-connection PORT-ADD src-shelf 3 src-slot 1 src-subslot 0 src-port E1
dst-shelf 1 dst-slot 0 dst-subslot 0 dst-port C1
Step 2
Provision a DROP connecon between the L100 client port and a PIL1-3PS2 edge port.
Command:
% set port-connection PORT-DROP src-shelf 1 src-slot 0 src-subslot 0 src-port C1
dst-shelf 3 dst-slot 1 dst-subslot 0 dst-port E1
Step 3
Repeat the preceding steps for each ADD/DROP connecon to be provisioned.
ROADM Turn-Up and Operations
Adding Degree to ROADM Node
269
Release 19.1.1 · Issue 1.1, May 2021
Fujitsu and Fujitsu Customer Use Only

Fujitsu 1FINITY L100 Specifications

General

Brand	Fujitsu
Model	1FINITY L100
Category	Server
Language	English