Fujitsu 1FINITY L100 - LED Descriptions

2.2.2
LED Descriptions
Table 19
LED and Condion
LED Color Condion
ALM Yellow Minor alarm
Red Crical or major alarm
O No alarm
FIND ME
Note: Supported only on L100
Issue 14, FC95453R11-I14, and
later.
O No power
Blue A CLI command has been used to acvate this LED
O Default state when powered on
C1…C9 Green Incoming opcal signal operang normally
Red Input port down
One of the following alarms is present:
■ powerOutOfSpecicaonHigh
■ powerOutOfSpecicaonLow
O Power o
E1 Green Incoming opcal signal operang normally
Yellow Payload Missing Indicaon (PMI)
High Reecon (HREF)
Backward Detect Indicaon-Opcal Layer (BDI-O)
One of the following alarms is present:
■ postBlockSpanAdjustmentInProgress
■ preBlockSpanAdjustmentInProgress
Red WDM Loss of Signal (LOS)
WDM power out of specicaon
One of the following alarms is present:
■ omsLossOfSignal
■ omsPowerOutOfSpecicaonHigh
■ omsPowerOutOfSpecicaonLow
■ oscPowerOutOfSpecicaonHigh
■ oscPowerOutOfSpecicaonLow
■ otsLossOfSignal
■ otsSpanlossOutOfSpecicaonHigh
■ otsSpanlossOutOfSpecicaonLow
O Power o
Unit Description
L100 Blade
68
Release 19.1.1 · Issue 1.1, May 2021
Fujitsu and Fujitsu Customer Use Only