Fujitsu 1FINITY L100 - Enable OSNR for Main Blade

7.2
Enable OSNR for Main Blade
Note: By default, the OSNR is disabled for a Main blade.
Step 1
Enter congure mode.
Command:
> configure
Step 2
Enable OSNR for all blades in NE.
Note: OSNR seng must be enabled in L100 Blade to support interoperability with L130 Blade.
Command:
% set wdmcfg osnr enable
Step 3
Save the changes.
Command:
% commit
Step 4
Verify OSNR sengs.
Command:
% show wdmcfg osnr
Output:
osnr enable
✓ This task is complete.
ROADM Turn-Up and Operations
Enable OSNR for Main Blade
255
Release 19.1.1 · Issue 1.1, May 2021
Fujitsu and Fujitsu Customer Use Only