Fujitsu 1FINITY L100 - Initial System Turn Up

5
Initial System Turn Up
In this chapter:
5.1 Log On
5.2 Set Up Main Blade (Inial)
5.3 Set WDM Conguraon
5.4 CONSOLE Port (Serial Port)
5.5 Congure OSPF Roung
5.6 Congure IP Connecon to DCN
5.7 Log On NE Through LMP
5.8 Provision Main Blade Ports and Fan Units
5.9 Enable Auto Shelf ID Assignment for Tributary Blade
Feature
5.10 Set Up Tributary Blade with Auto Shelf ID Assignment
Enabled
5.11 Set Up Tributary Blade without Auto Shelf ID
Assignment Enabled
5.12 Provision L100 Tributary Blade and Ports
5.13 Provision L110 Tributary Shelf, Ports, and Slots
5.14 Provision L160 Tributary Blade
5.15 Verify Blade Setup
5.16 Set ROADM Constraints
Initial System Turn Up
159
Release 19.1.1 · Issue 1.1, May 2021
Fujitsu and Fujitsu Customer Use Only