Fujitsu 1FINITY L100 - Configure Next-Hop

Virtuora User
Interface
WebGUI
CLI
NETCONF/
YANG
Router
Next-hop IP address
Virtuora NC
DCN
Switch
NE Management
Mode = Bridge
1FINITY NE
1FINITY NE
1FINITY NE
LCN1
LCN2
LCN2
LCN1
LCN1
LAN cable
Remote Users
NE Installation Site
DHCP Server
LAN
Figure 90
Daisy Chain LAN Connecon
Note: The NE that is being turned up connects to the end of the daisy chain. The other NEs must be congured
to bridge trac between LCN1 and LCN2 (set neMgmtMode to Bridge or MixMode).
Step 1
Change to CLI conguraon mode.
Command:
> configure
Congure Next-Hop
If the NE connects directly to the DCN, the next hop should be the address of the default router.
Step 2
Congure the next hop. This step creates the roung instance if it does not already exist.
Command:
% set routing routing-instance <routing_instance_name> routing-protocols routing-
protocol static <protocol_instance_name> static-routes ipv4 route 0.0.0.0/0 next-
hop next-hop-address <ip_address>
Parameter Value Descripon
routing_instance_name <MCN> Name of roung instance
protocol_instance_name <FNC> Name of protocol instance
ip_address <1xx.xxx.xxx.xxx> IP address of next hop
Command Example:
% set routing routing-instance MCN routing-protocols
routing-protocol static FNC static-routes ipv4 route 0.0.0.0/0
next-hop next-hop-address 192.168.229.254
Initial System Turn Up
Congure IP Connection to DCN
174
Release 19.1.1 · Issue 1.1, May 2021
Fujitsu and Fujitsu Customer Use Only