Fujitsu 1FINITY L100 - LCN Port Commands

6.12
LCN Port Commands
Note: The LCN port can have only one address at a me.
Note: When a new LCN IP address is entered, the address that is already on the LCN must be deleted before the
changes are commied.
Set LCN
This command provisions IPv4 or IPv6 address interface for LCN port.
Command:
% set interfaces interface <interface> <ipv4 | ipv6> <enabled> forwarding <packet-
forwarding> <true | false> address <ipv4-address | ipv6-address> prefix-length
<prefix-length>
Delete LCN
This command deletes the IP address interface for LCN port.
Command:
% delete interfaces <interface> <ipv4-address | ipv6-address>
System Administration
LCN Port Commands
238
Release 19.1.1 · Issue 1.1, May 2021
Fujitsu and Fujitsu Customer Use Only