Fujitsu 1FINITY L100 User Manual

Congure OSPF Routing
Step 8
Congure OSPF roung.
Command:
% set routing routing-instance <routing_instance_name> enabled routing-protocols
routing-protocol ospfv2 <protocol-instance-name> ospf instance
<routing_instance_name> ipv4 router-id <router-id> network <address> <mask> area
<area-id>
Parameter Value Descripon
routing_instance_name <MCN> Name of roung instance
protocol_instance_name <OSC> Name of roung protocol instance
router-id <1xx.xxx.xxx.xxx> OSPF router id per RFC 2328
address <1xx.xxx.xxx.xxx> IPv4 address, mask, and area ID dening the network on
which OSPF roung is enabled
mask <1xx.xxx.xxx.xxx>
area-id <x.x.x.x>
Command Example:
% set routing routing-instance MCN enabled routing-protocols
routing-protocol ospfv2 OSC ospf instance MCN ipv4 router-id 1.1.1.32
network 172.1.1.0 255.255.255.0 area 0.0.0.0
Step 9
Check the candidate conguraon, if desired.
Command:
% show routing routing-instance
Step 10
Save the changes.
Command:
% commit
Step 11
Exit conguraon mode.
Command:
% exit
✓ This task is complete.
Initial System Turn Up
Congure IP Connection to DCN
182
Release 19.1.1 · Issue 1.1, May 2021
Fujitsu and Fujitsu Customer Use Only

Fujitsu 1FINITY L100 Specifications

General

Brand	Fujitsu
Model	1FINITY L100
Category	Server
Language	English