Fujitsu 1FINITY L100 - Trailtracemismatch; Unequippedindication; Ztpbootfailure

trailTraceMismatch
Enty Type Severity
Service
Aected
Direcon Locaon Descripon
OC3 OSC (BDL1-3R11) major non–service-
aecng
receive NEND A mismatch exists on the trail trace
idener.
Probable Cause Suggested Correcve Acon
The Receive Source Access Point Idener
(RCVSAPI) is dierent from Expected Source
Access Point Idener (EXPSAPI), the
Receive Desnaon Access Point Idener
(RCVDAPI) is dierent from Expected
Desnaon Access Point Idener
(EXPDAPI), or both condions exist.
1. Ensure that the local EXPSAPI, EXPDAPI, or both are set
correctly to match the ones transmied from the far
end.
2. Ensure that the far-end transming Source Access
Point Idener (SAPI) and Desnaon Access Point
Idener (DAPI) match the local EXPSAPI and/or
EXPDAPI.
3. If the problem persists, verify the ber connecons for
add and drop connecons.
unequippedIndication
Enty Type Severity
Service
Aected
Direcon Locaon Descripon
OC3 OSC (BDL1-3R11) major service-
aecng
receive NEND An unequipped indicaon is received.
Probable Cause Suggested Correcve Acon
A WCH is not provisioned or equipped. 1. Verify that the correct blade type is installed.
2. Check the channel provisioning and correct if
necessary.
Cauon: The OSC must be acve for trac to be restored.
A failure of the OSC may keep trac from recovering on a
span.
ztpBootFailure
Enty Type Severity
Service
Aect
Direcon Locaon Descripon
COM major non–service-
aecng
n/a NEND ZTP Boot failure.
Probable Cause Suggested Correcve Acon
ZTP-Boot retries auto-upgrade aer 5
minutes.
No acon is required. ZTP-Boot retries auto-upgrade aer 5
minutes.
Note: This alarms clears at the end of 5 minutes.
System Maintenance
Trouble Clearing
340
Release 19.1.1 · Issue 1.1, May 2021
Fujitsu and Fujitsu Customer Use Only