Fujitsu 1FINITY L100 - Firmwaredownloadoractivationfailure; Firmwareinitinprogress

Enty Type Severity
Service
Aected
Direcon Locaon Descripon
BDL1-3B11, BDL1-3R11 minor non–service-
aecng
n/a NEND Firmware Version Limited Compability:
TYPE = <unit type>
Probable Cause Suggested Correcve Acon
The FW on the interface unit specied in the
alarm is not compable with the system
soware. All features are supported.
Load the appropriate FW.
rmwareDownloadOrActivationFailure
Enty Type Severity
Service
Aected
Direcon Locaon Descripon
BDL1-3B11, BDL1-3R11 minor service-
aecng
n/a NEND Firmware Download (FWDL)/Acvaon
Failure: TYPE = <unit type>
Probable Cause Suggested Correcve Acon
The FWDL or acvaon process failed. Retry the FWDL or acvaon process.
BDL1-3B11, BDL1-3R11 crical service-
aecng
n/a NEND FWDL/Acvaon Failure: TYPE = <unit type>
Probable Cause Suggested Correcve Acon
The FWDL or acvaon process failed. Retry the FWDL or acvaon process.
rmwareInitInProgress
Enty Type Severity
Service
Aected
Direcon Locaon Descripon
BDL1-3B11, BDL1-3R11 warning non–service-
aecng
n/a NEND Firmware INIT-EQPT in progress: TYPE =
<unit type>
Probable Cause Suggested Correcve Acon
A FW inializaon is in progress. No acon is required. This condion clears when the FW
inializaon completes.
System Maintenance
Trouble Clearing
312
Release 19.1.1 · Issue 1.1, May 2021
Fujitsu and Fujitsu Customer Use Only