Fujitsu 1FINITY L100 - Enable Auto Shelf ID Assignment for Tributary Blade Feature

5.9
Enable Auto Shelf ID Assignment for Tributary Blade Feature
Note: Auto Shelf ID Assignment feature is disabled by default.
Step 1
Connect to the Main blade.
Step 2
Enter congure mode.
Command:
> configure
Step 3
Enable tributary shelf ID assignment.
Command:
% set system trib-shelfid-assignment true
Step 4
Save the changes.
Command:
% commit
Step 5
Verify tributary shelf ID assignment.
Command:
% show system trib-shelfid-assignment
Output:
trib-shelfid-assignment true
✓ This task is complete.
Initial System Turn Up
Enable Auto Shelf ID Assignment for Tributary Blade Feature
188
Release 19.1.1 · Issue 1.1, May 2021
Fujitsu and Fujitsu Customer Use Only