Fujitsu 1FINITY L100 - Power Terminal Adapter

2.6
Power Terminal Adapter
The power terminal adapter is required when the L100 and L160 Blades are installed using the disaggregated
opon. The power terminal adapter provides dual –48 V DC (A and B) power feeds to the blade. One power
terminal adapter is required for each blade. The following gures show front and rear views of the power
terminal adapter.
Note: The power terminal adapter is not required if the 1FINITY six-slot Housing is used.
Protection Cover
s8102ah_2
Figure 28
Front View of Power Terminal Adapter
Unit Description
Power Terminal Adapter
85
Release 19.1.1 · Issue 1.1, May 2021
Fujitsu and Fujitsu Customer Use Only