Fujitsu 1FINITY L100 - Load Configuration Using NETCONF

A.1
Load Conguration Using NETCONF
In this secon:
A.1.1 Save Conguraon File
A.1.2 Edit XML Conguraon File
A.1.1
Save Conguration File
Save the conguraon XML le in conguraon mode.
Command:
> run show configuration | display xml | save FUJITSU-L100_config.xml
A.1.2
Edit XML Conguration File
Add Header—
Load Replace
Edit the conguraon le to add the header for load replace operaon.
Example:
<edit-config>
<default-operation>replace</default-operation>
<target>
<candidate/>
</target>
<test-option>set</test-option>
<config xmlns="http://tail-f.com/ns/config/1.0">
………… configuration saved in previous step
</config>
</edit-config>
Commit Changes
Save the changes.
Command:
<commit/>
Load
Conguration Operation
Load Conguration Using NETCONF
450
Release 19.1.1 · Issue 1.1, May 2021
Fujitsu and Fujitsu Customer Use Only