Fujitsu 1FINITY L100 - SSH Server Service

Enable/Disable SNMP Alarm Trap Nocaon
By default, the SNMP alarm trap nocaon is enabled.
Command:
% set system services snmp alarm-trap <enabled|disabled>
Enable/Disable SNMP Authencaon Failure Trap Nocaon
By default, the SNMP authencaon failure trap nocaon is enabled.
Command:
% set system services snmp authFailureTrap <enabled|disabled>
Enable/Disable SNMP Event Trap Nocaon
By default, the SNMP common event trap nocaon is enabled.
Command:
% set system services snmp event-trap <enabled|disabled>
Enable/Disable SNMP TCA Trap Nocaon
By default, the SNMP TCA trap nocaon is enabled.
Command:
% set system services snmp tca-trap <enabled|disabled>
6.14.6
SSH Server Service
Note: CLI uses the SSH server service.
Show SSH Server Conguraon
Command:
% show system services ssh-server
Enable/Disable SSH Server
By default, the SSH server service is enabled.
Command:
% set system services ssh-server ssh-server-enabled <true|false>
System Administration
System Services
244
Release 19.1.1 · Issue 1.1, May 2021
Fujitsu and Fujitsu Customer Use Only