Fujitsu 1FINITY L100 - System Features

1.4
System Features
In this secon:
1.4.1 Autoprovisioning
1.4.2 Mulcommand Conguraon Commit
1.4.3 In-Service Upgrade
1.4.4 Proxy ARP
1.4.5 Scripng Automaon—Python
1.4.6 Secure Copy
1.4.7 System Zeroizaon
1.4.8 Root Access
1.4.9 CONSOLE Port
1.4.10 Congurable Log Files
1.4.11 Jumbo Frame Support with IP MTU Maximum 9574
Bytes
1.4.12 Postoutadj
1.4.13 OSC Power Adjustment
1.4.14 Crical Data Storage Feature
1.4.15 Automac Soware Download
1.4.16 Tributary Auto Shelf ID Assignment
1.4.1
Autoprovisioning
If autoprovisioning (autoP) is enabled, the system automacally congures all unprovisioned hardware (including
plug-in units and pluggable modules) when that hardware is rst installed in the system. The autoprovisioning
includes hardware present at inial system turn-up and hardware that is installed aer turn-up. Autoprovisioning
congures hardware to default sengs and creates default facilies, as required, which are congured to default
sengs.
Note: Autoprovisioning is enabled by factory default.
Note: Fujitsu recommends using the autoprovisioning feature rst and aerwards eding the provisioning
manually using CLI commands, if required.
1.4.2
Multicommand Conguration Commit
The L100 Blade supports commit command aer execung mulple commands without having to save each
conguraon change performed. User can execute a set of commands at any statement hierarchy level and save
the conguraon. Mulcommand conguraon commit is supported in both NETCONF and CLI.
Same Hierarchy—A set of commands used for same type of enes.
Command Examples (Same Hierarchy):
% set fabric och-connection XCON-ADD-CH1 src-if och-7/1/0/C1 dst-if ots-1/0/0/E1
dst-och 1
% set fabric och-connection XCON-DROP-CH1 src-if ots-1/0/0/E1 src-och 1 dst-if
och-7/1/0/C1
% set fabric och-connection XCON-ADD-CH2 src-if och-7/1/0/C2 dst-if ots-1/0/0/E1
dst-och 2
System Description and Engineering
System Features
41
Release 19.1.1 · Issue 1.1, May 2021
Fujitsu and Fujitsu Customer Use Only