Fujitsu 1FINITY L100 - Telemetry, Streaming; Ztp

Set NE Management Mode
Command:
% set system neMgmtMode <mgmtmode>
Parameter Value Descripon
mgmtmode
<Bridge, MixMode, Router> Bridge—Layer 2 bridging runs between management interfaces.
MixMode—Roung runs between all management interfaces,
except LCN1 and LCN2 which are bridged.
Router—Roung runs between management interfaces.
Show NE Management Mode
Command:
% show system neMgmtMode
6.6.4
Telemetry, Streaming
Note: For more detailed streaming telemetry informaon, refer to 1FINITY Telemetry User Guide, available on
the Fujitsu Partners website, hps://partners.fnc.fujitsu.com/documentaon.
Enable Streaming Telemetry
Streaming telemetry must be congured by the user via an XML conguraon le loaded to the NE. The
telemetry feature checks the conguraon le on system start-up and if the le is not found, telemetry service
shuts down.
By default, streaming telemetry is disabled.
Command:
> request telemetry action <telemetry-action> config-file <telemetry-filename>
Command Example:
> request telemetry action configure config-file /var/ftp/
telemetry.tar.gz
Disable Streaming Telemetry
Command:
> request telemetry action delete
6.6.5
ZTP
System Administration
System Feature Administration
218
Release 19.1.1 · Issue 1.1, May 2021
Fujitsu and Fujitsu Customer Use Only