Fujitsu 1FINITY L100 - CONSOLE Port (Serial Port)

5.4
CONSOLE Port (Serial Port)
In this secon:
5.4.1 Enable/Disable CONSOLE Logon
5.4.2 CONSOLE Log On
Note: Only L100 Blade Issue 14 (FC95453R11-I14) and later supports CONSOLE port.
5.4.1
Enable/Disable CONSOLE Logon
Note: The console logon is enabled by default.
Step 1
Verify console logon status.
Command:
> show system console console-enabled
Output:
console-enabled true;
[ok][date-time]
Step 2
Congure console logon (if disabled).
Command:
% set system console console-enabled true
Output:
[ok][date-time]
✓ This task is complete.
Initial System Turn Up
CONSOLE Port (Serial Port)
165
Release 19.1.1 · Issue 1.1, May 2021
Fujitsu and Fujitsu Customer Use Only