Fujitsu 1FINITY L100 - Configure System Time Zone

Enable/Disable NTP
Command:
% set system ntp <enabled|disabled>
Add NTP Server
Command:
% set system ntp servers <server_name> address <ip_address> prefer <prefer>
Parameter Value Descripon
server_name
<ntp> Name of server
ip_address
<1xx.xxx.xxx.xxx> IP address of server
prefer
<True, False> True—Enable server preference
False—Disable server preference
Command Example:
% set system ntp servers ntp-b.nist.gov address 132.163.96.5
[ok]
Seng prefer is oponal. If omied, prefer is set to false. Repeat, as required, for mulple NTP servers.
Remove NTP Server
Command:
% delete system ntp servers <server_name>
6.4.4
Congure System Time Zone
Set System Time Zone
Command:
% set system clock timezone-name <timezone>
Parameter Value Descripon
timezone
<CST6CDT> Name of me zone (TZ) database, for
example, America/Chicago, Europe/
Stockholm, or Asia/Tokyo
Show System Time Zone
Command:
% show system clock timezone-name
System Administration
System Time and Date
213
Release 19.1.1 · Issue 1.1, May 2021
Fujitsu and Fujitsu Customer Use Only