Fujitsu 1FINITY L100 - Snmpv3; Fujitsu Optical Interfaces

In this case, the new xcon-id=ABC is alphabecally smaller than the previously created fabric with xcon-
id=ABCDEF. As a result, the fabric xcon-id=ABC is executed rst, but the validaon fails at commit.
Important: Fujitsu recommends to prepend z and YEAR-MONTH-DAY-HR to the actual xcon-id when
the user creates the fabric.
Command:
% set fabric och-connection z-2019-12-05-13-ADD-FROM-SHELF2-C2 src-if
A.3.2
SNMPv3
In case of SNMPv3, user provisioning is present in the system. The save conguraon le does not contain the
authencaon and privacy passwords. The user enters the actual text password in the conguraon le before
execung the load merge or load replace command.
Example:
[-|#] <user>
<username>authuser1</username>
<authentication-protocol>md5</authentication-protocol>
<authentication-password>admin12345</authentication-password>
<privacy-protocol>des</privacy-protocol>
<privacy-password>admin12345</privacy-password>
</user>
A.3.3
Fujitsu Optical Interfaces
If the user saves the conguraon le in previous release, the user needs to delete <band-capability></
band-capability> and <amp-type></amp-type> from the conguraon data le before the execuon
of load conguraon feature.
In this release both elds are moved to operaon side.
Example:
<interface>
<name>ots-1/0/0/E1</name>
<type xmlns:ianaift="urn:ietf:params:xml:ns:yang:iana-if-
type">ianaift:opticalTransport</type>
<enabled>true</enabled>
<ots xmlns="urn:fujitsu:params:xml:ns:yang:interface:ot">
<admin-status>up</admin-status>
<fiber-type>smf</fiber-type>
<degree-number>1</degree-number>
<operation-mode>ope-mode-base</operation-mode>
<amp-type>edfa</amp-type> #amplifier type need to be deleted
<band-capability>lband</band-capability> #band capability need to be
deleted
</ots>
</interface>
Load
Conguration Operation
Limitations on Load Conguration
457
Release 19.1.1 · Issue 1.1, May 2021
Fujitsu and Fujitsu Customer Use Only