Fujitsu 1FINITY L100 - Page 142

Protection Cover
s8102ah_2
Figure 73
Removing Protecon Cover
Step 2
Aach the power cables to the power terminal adapter by performing the following substeps:
Warning: Make sure to use terminang cable lugs bent at 90 degrees if stacking mulple blades in a rack.
The cables make contact below the power terminal adapter if the lugs are not bent at 90 degrees.
FNC000070_Rev_01
Figure 74
Installing Power Cables
a) Aach the frame ground cable (green/yellow) to the terminal marked FG on the power terminal adapter.
b) Aach the ground cable (black) for the A power feed to the terminal marked GA on the power terminal
adapter.
c) Aach the power feed A cable (red) to the terminal marked MAIN A on the power terminal adapter.
Equipment Installation
Install Power Cables
142
Release 19.1.1 · Issue 1.1, May 2021
Fujitsu and Fujitsu Customer Use Only