Fujitsu 1FINITY L100 - Page 161

Step 3
Log on to the NE using factory default user credenals.
factory default username: fujitsu
factory default password: 1nity
Note: Fujitsu recommends changing the default username and password aer inial login.
Step 4
If appropriate, change to CLI congure mode.
Command:
> configure
Output Example:
Entering configuration mode
[ok]
Step 5
Proceed to the procedure that required the login.
✓ This task is complete.
Initial System Turn Up
Log On
161
Release 19.1.1 · Issue 1.1, May 2021
Fujitsu and Fujitsu Customer Use Only