Fujitsu 1FINITY L100 - Page 288

INPUT RATING:
-40 TO -57V
FUSED AT 15A
,10A MAX，
s8104ai_1
Figure 105
Rear View of L110 Opcal Mux Base Blade
Note: The Enty Type LED indicators are on the front of the SFP module installed in the corresponding SFP cage.
The FAN LED indicators are on the rear of the blade. All other LED indicators are on the front of the blade.
Note: In a mulblade conguraon, consisng of a Main blade and one or more tributary blades, only the ALM
LED on the Main blade lights when an alarm occurs on any of the blades.
Table 49
LED and Condion
LED Color Condion
SYS Green Normal operaon
Yellow Not ready (warm-up or SWDL in progress)
One of the following alarms is present:
■ databaseCorrupon
■ databaseLockedDbRestoreInProgress
■ databaseLockedIlfViolaon
■ databaseLockedShelfProvModePresent
■ databaseLockedSowareUpgradeInProgress
■ equipmentWarmup
■ rmwareDownloadOrAcvaonFailure
■ shelfProvisioningMode
■ sowareVersionMismatch
■ databaseVersionMismatch
■ rmwareBackwardCompableAll
■ rmwareInitInProgress
■ rmwareVersionMismatch
■ sowareStageInProgress
Red Equipment fault
Power-up state
Blinking red MEA
O Power o
ALM Yellow Minor alarm
Red Crical or major alarm
O No alarm
System Maintenance
Trouble Clearing
288
Release 19.1.1 · Issue 1.1, May 2021
Fujitsu and Fujitsu Customer Use Only