Fujitsu 1FINITY L100 - Page 75

Table 23 (Cont.)
Connector and Funcon
Connector Connector Type Funcon
E2 LC with shuer Add/drop connecon to client port (C1…C9) of L100 Blade on
ROADM degree 2
E3 LC with shuer Add/drop connecon to client port (C1…C9) of L100 Blade on
ROADM degree 3
E4 LC with shuer Add/drop connecon to client port (C1…C9) of L100 Blade on
ROADM degree 4
LED Descripons
Table 24
LED and Condion
LED Color Condion
C Red C1…C16 port input down
C1…C16 port power out of specicaon
Green Incoming opcal signal operang normally
O Power o
E Red E1…E4 port input down
E1…E4 port power out of specicaon
Green Incoming opcal signal operang normally
O Power o
F/S Red Equipment fault or equipment in power-up state
Blinking red MEA
Yellow Not ready (warm-up or SWDL in progress)
Green Normal operaon
O Power o
Unit Description
L110 Blade
75
Release 19.1.1 · Issue 1.1, May 2021
Fujitsu and Fujitsu Customer Use Only