CX2550/60/70 M4 Upgrade and Maintenance Manual 121
Expansion cards and OCP mezzanine cards
Ê If applicable, install SFP+ transceiver modules on the new expansion card,
see section "Installing SFP+ transceiver modules" on page 172.
6.2.1.3 Connecting cables to the expansion card
Ê If applicable, connect internal cables to the expansion card.
I For a complete cabling overview, see section "Cabling" on page 421.
6.2.1.4 Concluding steps
Perform the following procedures:
Ê "Installing the riser module" on page 55
Ê "Installing the server node in the server enclosure" on page 67
Ê Reconnect all external cables.
Ê "Controls and indicators on the server node" on page 448
Ê "Updating expansion card firmware" on page 83 (if applicable)
Ê "After replacing/upgrading LAN controllers" on page 100 (if applicable)
This is the good case.
This is the bad case.
To Next Page
Loading...
