Fujitsu PRIMERGY CX2550 M4

198 Upgrade and Maintenance Manual CX2550/60/70 M4
Main memory
7.4.2 Removing a memory module
Ê Identify the defective memory slot.
Ê Remove the defective memory module, see section "Removing memory
modules" on page 194.
7.4.3 Installing a memory module
Ê If applicable, prepare the new memory module, see section "Replacing
memory modules" on page 201.
Ê Install the new memory module, see section "Installing memory modules" on
page 190.
7.4.4 Concluding steps
Perform the following procedures:
Ê "Installing the memory slot air duct (Air cooling only)" on page 64
Ê "Installing the server node in the server enclosure" on page 67
Ê If applicable, reconnect all external cables.
Ê "Enabling replaced components in the BIOS" on page 89
Ê "Controls and indicators on the server node" on page 448
Ê "Verifying the memory mode" on page 90 (if applicable)
Ê "Enabling replaced components in the BIOS" on page 89
7.5 Memory module cooling pads for Liquid
Cooling (LC)
7.5.1 Basic information
I Before installing new memory modules prepare the memory modules
with the cooling pads.