CX2550/60/70 M4 Upgrade and Maintenance Manual 89
Basic software procedures
5.2.7 Enabling replaced components in the BIOS
When a CPU, an expansion card, or a memory module fails, the defective
component will be set to Disabled or Failed in the BIOS. The server will then
reboot with only the intact hardware components remaining in the system
configuration. After replacing the defective component, it needs to be re-
enabled in the BIOS.
Ê Enter the BIOS.
Ê Select the Configuration menu.
Ê Select the status menu of the desired component:
–CPUs: CPU Status
I This option is only available for multi-processor systems.
– Memory: Memory Status
– Expansion cards: PCI Status
Ê Reset replaced components to Enable.
Ê Save your changes and exit the BIOS.
I For more information on how to access the BIOS and modify settings,
see the corresponding BIOS Setup Utility reference manual.
To Next Page
Loading...
Need help?
General