90 Upgrade and Maintenance Manual CX2550/60/70 M4
Basic software procedures
5.2.8 Reconfiguring the backup software solution
I This task only applies to Japan.
Disabling backup drives
Depending on the backup software solution, it may be necessary to disable or
delete the backup drive from the backup software drive list and reconfigure
backup jobs after completing the maintenance task.
I More information on suitable backup software solutions and related
documentation is available from the Fujitsu web pages.
Re-enabling backup drives
If a backup drive has been disabled or deleted from the backup software drive
list as described in section "Removing backup and optical disk media" on
page 75, it has to be re-enabled to complete the maintenance task.
Ê Re-enable backup drives and revise backup software settings and cronjobs.
I More information on suitable backup software solutions and related
documentation is available from the Fujitsu web pages.
5.2.9 Verifying the memory mode
If a memory module fails, the server will reboot and the defective module will be
disabled. As a result, the current operation mode may no longer be available
due to a lack of identical memory module pairs. In this case, the operation mode
will automatically revert to Independent Channel Mode.
I For more information on memory operation modes available for your
server, see section "Operation modes" on page 187.
After replacing the defective module(s) the memory operation mode is
automatically reset to its original state. It is recommended to verify that the
operation mode has been correctly.
Ê Enter the BIOS.
Ê Select the Configuration menu.
Ê Under Memory Status verify that none of the memory modules are marked as
Failed.
To Next Page
Loading...
Need help?
General