96 Upgrade and Maintenance Manual CX2550/60/70 M4
Basic software procedures
5.2.13 Resuming BitLocker functionality
If BitLocker Drive Encryption has been suspended for maintenance purposes
(see section "Suspending BitLocker functionality" on page 71), it has to be re-
enabled to complete the service task.
I If BitLocker Drive Encryption has been suspended prior to replacing
components you won't be asked for a recovery key when rebooting the
server after the maintenance task. However, if BitLocker functionality has
not been suspended, Windows will enter recovery mode and ask you to
input recovery key for further booting.
Ê In this case, ask the system administrator to enter the recovery key in
order to boot the operating system.
Ê Ask the system administrator to enable the previously suspended BitLocker-
protection on the system volume, using the BitLocker Drive Encryption control
panel item:
For Windows Server 2008:
Ê Click Start - Control Panel - Security, - BitLocker Drive Encryption to open
the BitLocker Drive Encryption.
Ê Select the system volume, and click Turn On BitLocker.
For Windows Server 2008 R2 and above:
Ê Click Start - Control Panel - System and Security - BitLocker Drive Encryption
to open the BitLocker Drive Encryption.
Ê Select the system volume, and click Resume Protection.
I For more information on how to resume BitLocker drive encryption, see
the Microsoft TechNet library at
http://technet.microsoft.com/library/cc731549.aspx.
For more information, see the Fujitsu web pages.
To Next Page
Loading...
