318 Upgrade and Maintenance Manual CX2550/60/70 M4
System board and components
Ê "Installing the iRMC microSD card" on page 292 (if applicable)
Ê Reconnect all cables to the system board. For a complete cabling overview,
see section "Cabling overview" on page 420.
Ê "Installing OCP mezzanine cards" on page 159 (if applicable)
Ê "Installing the riser module" on page 55
I Install the expansion cards into their original slots.
Ê "Installing the FBU" on page 139 (if applicable)
Ê "Installing a memory module" on page 191
I Install the memory modules into their original slots.
9.6.3 Concluding steps
Perform the following steps:
Ê "Installing the server node in the server enclosure" on page 67
Ê If applicable, reconnect all external cables.
Ê "Controls and indicators on the server node" on page 448
Ê "Verifying system information backup / restore" on page 83
Ê "Using the Chassis ID Prom Tool" on page 99
This action is not required if the system information restore is successfully
done.
Ê "Updating or recovering the system board BIOS and iRMC" on page 77 (if
applicable)
Ê "Verifying the system time settings" on page 92
Ê Inform the customer about changed WWN and MAC addresses. For further
information, see section "Looking up changed MAC/WWN addresses" on
page 97.
To Next Page
Loading...
