CF Column Adjust Fine Tune
This command fine-tunes the Column Offset setting by shifting both the horizontal
start of print position and the Label Width termination point to the right in dots to
compensate for slight mechanical differences sometimes evident when multiple
printers share label formats.
Parameter: CF
Value / Range: + / – dots
Units / Interpretation: Resolution specific (see Print Resolutions and
Maximum Width & Record Column Values).
Command Equivalent: N/A
CH Communicated Heat Commands
This command causes the printer to ignore DPL Heat commands. Ignore by setting
value to N. Process by setting value to Y (default). When set to ignore Heat commands
values are controlled via the menu setting.
Parameter: CH
Value / Range: Y, N or 1, 0
Units / Interpretation: Y = Enabled, N = Disabled; or 1 = Enabled, 0 = Disabled
Command Equivalent: N/A
CL Continuous Label Length
See <STX>c for command details.
Parameter: CL
Value / Range: 0 - 9999
Units / Interpretation: 1/100 in. or 1/10 mm
Command Equivalent: <STX>c
CO Column Offset
See Cnnnn for command details.
Parameter: CO
Value / Range: 0 - 9999
Units / Interpretation: 1/100 in. or 1/10 mm;
Command Equivalent: Cnnnn
80
DPLCommand Reference
To Next Page
Loading...
Need help?
General