LABEL FORMATTING
COMMANDS
The <STX>L command switches the printer from the System-Level Processor to the
Label Formatting Processor. All commands following the <STX>L are interpreted as
label formatting commands, and can be used to override default parameter values.
Selectable parameter value defaults may be also reassigned via the Setup Menu, as
defined in the corresponding Operator's Manual. Label formats that contain no
commands overriding printer default values will assume those defaults.
l
: Set Cut by Amount
l
A Set Format Attribute
l
B Barcode Magnification
l
C Set Column Offset Amount
l
D Set Dot Size Width and Height
l
E Terminate Label Formatting Mode and Print Label
l
e Recall Printer Configuration
l
F Advanced Format Attributes
l
G Place Data in Global Register
l
H Enter Heat Setting
l
J Justification
l
M Select Mirror Mode
l
m Set Metric Mode
l
n Set Inch (Imperial) Mode
l
P Set Print Speed
l
p Set Backfeed Speed
l
Q Set Quantity of Labels to Print
l
R Set Row Offset Amount
l
r Recall Stored Label Format
l
S Set Feed Speed
l
s Store Label Format in Module
l
T Set Field Data Line Terminator
DPL Command Reference
128
CHAPTER
6
To Next Page
Loading...
Need help?
General