SOH B Toggle Pause
This command toggles the printer's paused state between "On" and "Off." (This is the
same function achieved by pressing the PAUSE Key.)
Syntax
<SOH>B
Behavior
This command will illuminate the Paused/Stop Indicator and/or indicate PAUSED on
the LCD or graphics display panel, suspend printing, and wait until one of the
following occurs:
l
The <SOH>B command is sent to the printer.
l
The PAUSE Key is pressed.
Upon which the printer will turn the Paused/Stop Indicator "Off" and/or remove
PAUSED from the LCD or graphics display, then resume operation from the point of
interruption. (If the Receive Buffer is not full, an <XON> character will be transmitted
from the printer.)
SOH C Stop/Cancel
This command performs the cancel print job function (same function as pressing the
STOP/CANCEL key). The command clears the current format from the print buffer,
pauses the printer, and illuminates the Paused/Stop Indicator. The pause condition is
removed as described under <SOH>B.
Syntax
<SOH>C
Behavior
The print buffer is cleared and the Paused/Stop Indicator is illuminated (and/or
PAUSED is displayed on the LCD or graphics display) as operations are suspended,
until one of the following occurs:
l
The <SOH>B command is sent to the printer; or
l
The PAUSE Key is pressed.
Upon which the printer will turn the Paused/Stop Indicator "Off" and/or remove
PAUSED from the LCD or graphics display. (If the Receive Buffer is not full, an <XON>
character will be transmitted from the printer.)
SOH D SOH Shutdown
This command is ignored by the printer.
DPL Command Reference
6
To Next Page
Loading...
