SF Save As Filename
This command, which may be sent separately or included as the last command in an
<STX>Kc command string, saves the effective printer configuration to a file in Flash
memory with a .dcm file extension.
Parameter: SF
Value / Range: Alphanumeric string
Units / Interpretation: Up to 16 characters
Command Equivalent: N/A
SG Sensor Gain Value
This command sets the control of the voltage to the LED emitter of the Media Sensor.
Parameter SG
Value / Range: 0 - 32
Units / Interpretation: N/A
Command Equivalent: N/A
Sl Security Lock
This command provides the ability to password-protect the User Interface.
Parameter SI
Value / Range: N, Y, T
Units / Interpretation: See table below.
Command Equivalent: N/A
Value Security Function
Nxxxx Where xxxx is the current password, this disables Menu protection.
Yxxxx
Where xxxx is a new password, this enables Menu protection and sets
a new password.
Txxxx
Where xxxx is a new password, this enables Menu protection, disables
Test functions, and sets a new password.
Note: To be activated, the default password (0000) must be changed.
SL Stop Location
This command sets the label stopping (and in certain cases the starting) location.
DPL Command Reference
119
To Next Page
Loading...
Need help?
General