l
t Add or subtract date time from the printer date
l
U Mark Previous Field as a String Replacement Field
l
X Terminate Label Formatting Mode
l
y Select Font Symbol Set
l
z Zero (Ø) Conversion to "0"
l
+ | > | ( Make Last Field entered an Increment Field
l
– |< | ) Make Last Field entered a Decrement Field
l
^ Set Count by Amount
l
STX D Print adjusted date
l
STX S Recall Global Data and Place in Field
l
STX T Print Time and Date
: Set Cut by Amount
This command allows a predetermined number of labels to be printed before a cut is
initiated. This feature is useful when it is necessary to print an uncut strip of labels.
Between 1 and 9999 labels may be printed before a cut is made. The amount must be
smaller than the quantity of labels printed.
Syntax
: nnnn
Parameters
Where:
l
nnnn - Is a four digit decimal number indicating the number of labels to be printed
before a cut is performed.
Sample
<STX>L<CR>
:0005<CR>
141100001000100SAMPLE LABEL<CR>
Q0021<CR>
E<CR>
Result
The sample above instructs the printer to make a cut after 5, 10, and 20 labels have
been printed. Label 21 will be cut at the start of a subsequent label format (batch)
unless a default (cut by amount) greater than one has been entered.
Limitations
The cutter must be enabled with all mechanism interlocks closed for operation.
129
DPLCommand Reference
To Next Page
Loading...
Need help?
General