^ Set Count by Amount
This command allows applications using the increment / decrement field command
to print more than one label with the same field value before the field data is updated.
The default is 1.
Syntax
^nn
Parameters
Where:
l
^ - 0x5E or 0x40 if using Alternate or Alternate 2 Control Codes.
l
nn - Is a two-digit value that specifies the number of labels to be generated before
incrementing (or decrementing) the field value.
Behavior
This command can only be issued once per label format. In addition, when alternate
Control Codes are enabled, the "^" character must be replaced by the "@" character
(hexadecimal 0x40); see Control Code Command Functions.
Sample
<STX>L
13220000000000012345
-01
^02
Q0006
E
Result
The sample above prints two labels containing the same field value before
decrementing the field. Six labels are printed.
DPL Command Reference
150
To Next Page
Loading...
Need help?
General