Value / Range: Y, N
Units / Interpretation: Y = Enabled, N = Disabled
Command Equivalent: N/A
RR Rewinder Adjust
This command changes the torque applied by the powered rewinder, in percentage
points of the nominal force, to minimize TOF registration drift (sometimes evident
when using small or narrow media).
Parameter RR
Value / Range: -xx, +yy
Units / Interpretation: Applied torque, where -30 to +15 is the valid range.
Command Equivalent: N/A
RS Ribbon Low Signal
This command sets the signal output type for the Ribbon Low Diameter condition
when using the optional GPIO. See General Purpose Input Output (GPIO) Port
Applications for more information.
Parameter RS
Value / Range: 3, 4
Units / Interpretation: 3 = Active Low, 4 = Active High
Command Equivalent: N/A
RV Reflective Paper Value
This command sets the threshold value for the reflective media sensor’s paper
parameter.
Parameter RV
Value / Range: 0 - 255
Units / Interpretation: N/A
Command Equivalent: N/A
RW Retract Delay
This command sets a time delay for the retraction of a presented label, where the time
specified is multiplied by ten milliseconds.
Parameter RW
DPL Command Reference
117
To Next Page
Loading...
Need help?
General