l
STX O Set Start of Print (SOP) Position
l
STX o Cycle Cutter
l
STX P Set Hex Dump Mode
l
STX p Controlled Pause
l
STX Q Clear All Modules
l
STX q Clear Module
l
STX R Ribbon Saver Control
l
STX r Select Reflective Sensor
l
STX S Set Feed Speed
l
STX T Print Quality Label
l
STX t Test DRAM Memory Module
l
STX U Label Format String Replacement Field
l
STX V Software Switch Settings
l
STX v Request Firmware Version
l
STX W Request Memory Module Information
l
STX w Test Flash Memory Module
l
STX X Set Default Module
l
STX x Delete File from Module
l
STX Y Output Sensor Values
l
STX y Select Font Symbol Set
l
STX Z Print Configuration Label
l
STX z Pack Module
STX A Set Time and Date
This command sets the time and date. The initial setting of the date will be stored in
the printer’s internal inch counter. This date can be verified by printing a
configuration label.
Syntax
<STX>AwmmddyyyyhhMMjjj
Parameters
Where:
l
w - 1 digit for day of week; 1 = Monday; 7 = Sunday
l
mm - 2 digits for month
10
DPLCommand Reference
To Next Page
Loading...
